|
|
| (One intermediate revision by one other user not shown) |
| Line 1: |
Line 1: |
| ==iCubInterface/yarpdev==
| |
| If the error is:
| |
| yarpdev: ***ERROR*** driver <canmotioncontrol> was found but could not open
| |
| Try to run the "canLoader" and connect to all the boards with the "pcan" interface.
| |
| * A board might not be connecting properly. --> Try to reboot the boards and check the canLoader IDs.
| |
| * An ID might be with the value 15 (which is wrong, the IDs go from 0 to 4).
| |
| Solution (not a really trustful one): check connection between the boards.
| |
|
| |
|
| ==Motor problems==
| |
| * '''<span style="color:red">!!!Check if the data cables are all working!!!</span>'''
| |
| * Right forearm pronation motor (motor 2) has the same problem has the eyes tilt motor.
| |
| * Left arm wrist flection motor (motor 4) has encoder problems.
| |
| * Right arm wrist flection motor (motor 4) is and old motor that needs to be replaced.
| |
| * Last but not least there backlashes everywhere!!!
| |
|
| |
|
| |
| [[Vizzy|<< Back to Vizzy wiki homepage]]
| |
|
| |
| [[Category:Robots]]
| |
| [[Category:Vislab]]
| |